The Document describes how to connect and configure W04FXO Media Gateway.
Useful links:
Created: September 2020
Permalink: https://confluence.wildix.com/x/swGmB
Overview and LED indicators
04FXO Overview
1 - DC 12V power supply (optional)
2 - FXO ports 1-4
3 - WAN/ PoE port
4 - LAN port
5 - FXO 1-4 LED indicators
6 - Power indicator: shows power supply status
7 - Running indicator: indicates network registration status
8 - Reset button
LED indicators description
| Indicator | Definition | Status | Description |
|---|---|---|---|
| PWR | Power indicator | On | The device is powered on |
| Off | There is no power supply or power supply is abnormal | ||
| RUN | Running indicator | Slow flashing | The device is running properly |
| Fast flashing | SIP registration is successful | ||
| Off | The device is running improperly | ||
| FXO 1-4 | FXO In-use indicators | On | FXO port is currently occupied by a call |
| Off | FXO port is idle or faulty | ||
| WAN/PoE/ LAN | Network indicators | Green flashing | The device is properly connected to network |
| Off | The device is not connected to network or the connection is improper |
Installation and network connection
- Connect network cable to WAN/ PoE port
- Connect analog line to the FXO port(s)
Note: W04FXO 2020 is a wall-mounted Media Gateway.
Network connection
The Gateway works in two network modes: Route and Bridge modes.
LAN port is configured in Bridge mode and WAN port is set up as a DHCP Client. Connect one of two ports to the same network as the PBX or an external DHCP server (for instance, its router).
As soon as the DHCP server assigns an IP address to the Gateway, you can pass to the next step of the Gateway configuration.
- In case the PBX is used as a DHCP server, the gateway is detected on the network automatically
- In case an external DHCP server is used, check the list of the active leases to detect the IP address assigned to the Gateway
Provisioning
Follow our Provisioning of Wildix devices - Admin Guide to provision the gateway.
For remote/ unreachable media gateways behind NAT/Firewall, follow our online Guide to remote provisioning.
Configuration
Follow ISDN - FXO - GSM - SIP Trunk Settings Admin Guide to correctly set up the trunk parameters of the FXO gateway.
Factory reset
- Use the paper clip or the object of the similar shape to press the Reset button
- Keep the button pressed up to 15 seconds
- When PWR and RUN LED indicators become steady green, the reset of the Gateway is complete