Document description
Created: March 2019
Permalink:
POST Mode(safe mode)
Access Post Mode Process
Note: Please set the FTP server correctly and configure you PC IP is at range of 192.168.10.* before do the following steps.
- Connect Use cable connect PC to LAN port of W-PA.
- Power off the gateway.
3 keep pressed both volume keys and power and keep pressed for about 10 seconds. Then you can telnet.
4 On your PC, please telnet 192.168.10.1
5 Configure page as below:
Post Mode Clear
- Input 3 and enter for clear configuration:
Update Firmware in Post Mode
Note: Please set the FTP server correctly before doing the following step.
- Input 2 for update firmware
The server address is the IP of your PC.
The image name is the name of the firmware you place in FTP server directly.
Phone provides safe mode. When there is booting problem because of setting problem or firmware problem. User can restore the factory setting or upgrade to a new firmware to solve this problem.
Save and Reboot your W-PA
Input 4 for exit and reboot
Access to W-PA
Use the last known ip address of your W-PA on your browser and configure the auto provisioning like habitually
PS: plug headphone and press volume + (5s) to hear the address ip set on the wan card