Scroll export button | ||||||||
---|---|---|---|---|---|---|---|---|
|
Info |
---|
The Guide describes and explains how to provision Wildix devices. WMS Version: 5.0X / 6.0X Updated: September 2023 Permalink: https://wildix.atlassian.net/wiki/x/OxnOAQ |
Table of Contents |
---|
Introduction
...
Note |
---|
Note: Starting from WMS 6.03.20230630.3, the logic was updated to avoid HTTP protocol for device provisioning for improved security. With the update to WMS 6.03, devices are switched to HTTPS protocol by default, except for some old devices (e.g. some old FXS/FXO, W01GSM and old WP phones like WP400, WP500). If required, HTTP protocol can be set by the "HTTPForceUse" custom provisioning parameter. Documentation: Provisioning Custom Settings |
Auto-provisioning (Automatic mode) (Hardware, Virtual PBX)
...
...
- Go to WMS -> Devices
- Click + Add for provisioning of devices
- Select Automatic mode and click Next
- Click Scan (you can also specify the IP range for the search):
- Select your device(s) on the list and click Next
- Wait till the device is provisioned:
- Click Finish
...
Refer to the chapter How to assign Wildix phones to users of WMS online Guide for getting details about assigning procedure.
Remote provisioning (Semi-automatic mode)
...
...
Read this detailed online Guide for remote provisioning of each Wildix device.
Auto-configuration (auto.wildixin.com provisioning)
...
Auto-configuration allows you to automatically add and provision Wildix devices during new installations/ devices that had been reset.
...