DaySaver Quick Installation Guide helps you install and configure the GSM gateway. Thanks to GSM gateway it is possible to send SMS using your Wildix PBX and to call mobile numbers using the GSM SIM card.
WMS Version: starting from 3.88.43544.04
Created: February 2019
Permalink: https://confluence.wildix.com/x/Z4A2Ag
Please note that currently SMS functionality is not supported. It will be available later.
Overview and LED indicators
DaySaver Overview
Front panel:1 - SIM slot
2 - SIM LED indicator
3 - LAN LED indicator
4 - Running indicator
5 - Power indicator
6 - WAN LED indicator
7 - 2 antennas
Rear panel:1 - Optional power supply
2 - WAN/ PoE
3 - LAN port
4 - Reset button
5 - Reboot button
LED indicators description
Indicator | State | Description |
---|---|---|
PWR | Off | There is no power supply or it is abnormal |
On | The device is powered on | |
RUN | Off | The device is not running normally |
On | The device is being initialized | |
Slow flashing | The device is successfully initialized and running normally | |
WAN/ LAN | Off | The is no network connection |
Fast flashing | Network is successfully connected | |
SIM | Slow flashing 4 sec | SIM card cannot be detected (flashing ever 4 seconds) |
Fast flashing | SIM card has been inserted and successfully registered (flashing every 2 seconds) |
Installation and connection
Make sure the PIN code of the SIM card is disabled.
- Connect antennas to the rear panel of the gateway
- Connect network cable to WAN or LAN port
- Insert a SIM card to the SIM slot
Provisioning and configuration
Provisioning of Wildix devices Guide
Remote Provisioning of Wildix devices Manual
WMS -> Devices:
WMS -> Trunks:
Important: Status of signal quality is currently not supported!
After the device is provisioned, you can configure its settings. Consult Trunk Settings Guide to check all available parameters.
VoLTE configuration
To configure VoLTE, proceed with the following steps:
- Go to Network -> VoLTE
- Check off Enable in Status field
- Click Save
- Confirm by clicking Apply
Status -> Overview
Factory reset
To perform a factory reset procedure:
- Press and hold Reset button for 10 seconds
Important: complete initialization and loading can take up to 5 minutes!