Page Comparison

<div id="fb-root"></div>
<script>(function(d, s, id) {
  var js, fjs = d.getElementsByTagName(s)[0];
  if (d.getElementById(id)) return;
  js = d.createElement(s); js.id = id;
  js.src = 'https://connect.facebook.net/en_US/sdk.js#xfbml=1&version=v2.11';
  fjs.parentNode.insertBefore(js, fjs);
}(document, 'script', 'facebook-jssdk'));</script>

...

...

1. First of all, you need to reset the DaySaver:
   1. Open the DaySaver web interface 
   2. Go to System -> Backup/Restore/Upgrade -> Backup/Restore

   3. In the section Reset to defaults, tick off all the options and click Reset
      
      

      Warning
      Important: If DaySaver firmware is lower than v. 2.53.4.33, before proceeding with the configuration, go to DaySaver web interface -> Network Settings -> disable the option Disable Private Internets(RFC2918) DNS responses -> save the settings, and reboot the device.  Image Added

      
      

2. Disable limitations for DNS queries on the Main PBX. Consult the following documentation on how to do it: /wiki/spaces/DOC/pages/30279583
3. Check the provisioning file /rw2/etc/provision.conf and in case it contains the parameter FailoverByDns=yes, change its value to ‘no’: FailoverByDns=no, consult the documentation for details: Provisioning Custom Settings

4. Provision DaySaver to PBX in an automatic mode (Auto-provisioning), documentation: Provisioning of Wildix devices - Admin Guide

   Note
   Note: Sometimes you may need to wait for up to 5 minutes before DaySaver gets provisioned.

   
   

5. Configure the following settings in the WMS:
   
   
   1. In WMS -> Devices, select the DaySaver and clickEdit
   2. Fill out DNS server fields as mentioned below:
      
      
      • DNS Server: enter the IP address of the Main PBX 
      • Secondary DNS: enter the IP address of the Failover PBX
        
        
   3. Enable the checkbox Use received IP and click Save
   4. Click Configure/ Sync the device for the DNS settings to apply
   5. Wait for 1 or 2 minutes and go to DaySaver web interface and reboot the device
      
      
6. In the provisioning file /rw2/etc/provision.conf, add the parameter FailoverByDns=yes and the section [daysaver]
7. In WMS -> Devices, clickConfigure/ Sync the device again. The device should reboot. If it doesn’t, reboot it from its web interface

8. Check SIP configuration on the web interface of the device: the SIP Server Address and Outbound Proxy Address fields should contain the domain name auto-wildixin.com