...
...
Scroll export button | ||||||||
---|---|---|---|---|---|---|---|---|
|
Info |
---|
This document outlines steps that are required to configure failover by DNS for DaySaver. Created: October 2021 Updated: November 2021 Permalink: https://confluencewildix.wildixatlassian.comnet/wiki/x/FYfZBQIyDOAQ DaySaver documentation: https://confluencewildix.wildixatlassian.comnet/wiki/x/Z4A2Ag 7wbOAQ |
Note |
---|
Note: This configuration is supported starting from WMS 5.04 Beta. |
- First of all, you need to reset the DaySaver:
- Open the DaySaver web interface
- Go to System -> Backup/Restore/Upgrade -> Backup/Restore
In the section Reset to defaults, tick off all the options and click Reset
Warning Important:
...
If DaySaver firmware is lower than v. 2.53.4.33, before proceeding with the configuration,
...
go to DaySaver web interface -> Network Settings -> disable the option Disable Private Internets(RFC2918) DNS responses -> save the settings, and reboot the device.
...
- First, you need to disable
- Disable limitations for DNS queries on the main Main PBX. Consult the following documentation on how to do it: /wiki/spaces/DOC/pages/30279583
- Check the provisioning file /rw2/etc/provision.conf and in case it contains the parameter FailoverbyDNSFailoverByDns=yes, change its value to ‘no’:
FailoverbyDNSFailoverByDns=noDocumentation, consult the documentation for details: Provisioning Custom Settings Provision DaySaver
onto PBX in an automatic mode (Auto-provisioning)
.
Documentation, documentation:
Provisioning of Wildix devices - Admin Guide
Go toNote Note: Sometimes you may need to wait for up to 5 minutes before DaySaver gets provisioned.
- Configure the following settings in the WMS:
- In WMS -> Devices
- , select the
- DaySaver and clickEdit
- Fill out DNS server fields as mentioned below:
- DNS Server:
- enter the IP address of the Main PBX
- Secondary DNS: enter the
- IP address of the Failover PBX
- Enable the checkbox Use received IP and click Save
Then, select the device and click- Click Configure/ Sync the device for the DNS settings to apply
Device should now reboot. If it doesn’t, reboot it from the web interface.- Wait for 1 or 2 minutes and go to DaySaver web interface and reboot the device
- In the custom provisioning filenano-tiny /rw2/etc/provision.conf, add the parameter FailoverbyDNS FailoverByDns=yes and add the section [daysaver].
Documentation: Provisioning Custom Settings - In WMS -> Devices, clickConfigure/ Sync the device again. The device should reboot. If it doesn’t, reboot it from its web interface.Then, check
Check SIP configuration on the web interface of the device:
inthe SIP Server Address and Outbound Proxy Address fields
thereshould
becontain the domain name auto-wildixin.com
.
Macrosuite divider macro | ||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Button macro | ||||||||||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|