Page Comparison

...

...

1. First of all, you need to reset the DaySaver:
   1. Open the DaySaver web interface 
   2. Go to System -> Backup/Restore/Upgrade -> Backup/Restore

   3. In the section Reset to defaults, tick off all the options and click Reset
      
      

      Warning
      Important:

...

1. 1. If DaySaver firmware is lower than v. 2.53.4.33, before proceeding with the configuration,

...

1. 1. go to DaySaver web interface -> Network Settings -> disable the option Disable Private Internets(RFC2918) DNS responses -> save the settings, and reboot the device.

...

1. First, you need to disable

   1. Image Added

      
      

2. Disable limitations for DNS queries on the main Main PBX. Consult the following documentation on how to do it:  /wiki/spaces/DOC/pages/30279583 
3. Check the provisioning file /rw2/etc/provision.conf and in case it contains the parameter FailoverbyDNSFailoverByDns=yes, change its value to ‘no’:
   FailoverbyDNSFailoverByDns=noDocumentation, consult the documentation for details: Provisioning Custom Settings

4. Provision DaySaver

   on

   to PBX in an automatic mode (Auto-provisioning)

   .
   Documentation

   , documentation:

    

   Provisioning of Wildix devices - Admin Guide

   Go to

   Note
   Note: Sometimes you may need to wait for up to 5 minutes before DaySaver gets provisioned.

   
   

5. Configure the following settings in the WMS:
   
   
   1. In WMS -> Devices
   ->
   1. , select the
   device you're configuring, clickEdit and add two custom DNS servers
   1. DaySaver and clickEdit
   2. Fill out DNS server fields as mentioned below:
      
      
      • DNS Server:
   paste
   1. • enter the
   mainVM IP
   1. • IP address of the Main PBX 
      • Secondary DNS: enter the
   failover
   1. • IP address of the Failover PBX
   IP
   1. • 
        
   Also, enable
   1. • 
        
   2. Enable the checkbox Use received IP and click Save
   .
   Then, select the device and click
   2. Click Configure/ Sync the device for the DNS settings to apply
   .
   Device should now reboot. If it doesn’t, reboot it from the web interface.
   2. Wait for 1 or 2 minutes and go to DaySaver web interface and reboot the device
      
      
6. In the custom provisioning filenano-tiny  /rw2/etc/provision.conf, add the parameter FailoverbyDNS FailoverByDns=yes and add the section [daysaver]. 
   Documentation: Provisioning Custom Settings
7. In WMS -> Devices, clickConfigure/ Sync the device again. The device should reboot.   If it doesn’t, reboot it from its web interface.Then, check

8. Check SIP configuration on the web interface of the device:

   in

   the SIP Server Address and Outbound Proxy Address fields

   there

   should

   be

   contain the domain name auto-wildixin.com

   .