...
5 - Volume + button
6 - Reset button key
7 - Speaker 3 output interface: connect external speaker or MIC
...
1 - Speaker 1 interface: according to the device input voltage adaptive output maximum power; 4Ω speaker, POE / 8W, 12V / 10W, 18V / 20W, 24V / 30W. The greater the horn impedance, the smaller the output power. Suggested wire diameter: 18AWG or larger diameter.
2 - Speaker 2 interface: connect external headsets or active speakers
3 - LED interface: 5V output, connect an external LED, indicating the network, call and registration statuses
4 - Switch input 2 Function key interface: connect switch components to this interface
5 - MIC interface: it is recommended to use an electret condenser microphone (sensitivity: -38dB, bias voltage: 2.2V) and connect it with a shielded cable to the grounding screw to improve anti-interference
6 - Switch input 2 interface: connect switch components to this interface
7 - Switch output interface: corresponds to the short-circuit (switch input 2) input interface, allows to control electric locks, alarm loghts and other equipment
8 - 12V ~ 24V 2A input Power input interface: 12~24V 2A input, according to the input voltage, determine the maximum W-PA output power power amplifier
Instalation of W-PA SIP Paging Gateway
...
- Go to WMS -> Devices
- Click Add
- Enter MAC address of the device (you can find it on the device label)
- Click Next. You will be forwarded to the provisioning window with the device information (MAC, Type and Provisioning URL)
- Click Finish
- Access W-PA web interface for configuration settings:
- Press Volume - button for 3 seconds to obtain its IP address
- IP address will be playbacked through the speaker
- First time access credentials: admin : admin
- After you log in W-PA web interface, go to System -> Auto Provision -> Static Provisioning Server and fill in the following information:
- Server Address: enter your PBX host address or public IP
- Configuration File Name: ?action=setaps
- Protocol Type: HTTPS
- Click Apply
- Go to System -> Tools -> Reboot phone
- Click Reboot button
- Confirm the reboot by clicking OK
- You will hear two audio signals: the first one is played at the beginning of the reboot, the second one is played after it is completed
Note |
---|
Note: in case you can see the model type, login1, the firmware version and the password of the device in WMS -> Devices> Devices, and the device Status is green, it means that it is provisioned. |
...
- Go to WMS -> Devices
- Choose your W-PA from the list of available devices and click Assign to user
Enter the extension number of a user you want to assign the device to
Note Note: you can assign W-PA to an existing user or create a new one in WMS → -> Users
Public announcer function
...
Call the extension number you've assigned the device to from any Wildix IP phone/ Collaboration/ Mobile app
The device will auto answer and play back your voice over SPK1 and/ or SPK2
If you want to finish broadcasting, click Hangup (red) icon to hang up a call
Factory reset
In case you need to reconfigure your W-PA, you should perform a reset procedure.
To restart and restore the factory settings of W-PA SIP Paging Gateway:
Press the Reset key with a paperclip and hold it for 3 seconds the Reset buttonseconds
Html |
---|
<div class="fb-like" data-href="https://confluence.wildix.com/x/BQAVAQ" data-layout="button_count" data-action="recommend" data-size="large" data-show-faces="true" data-share="true"></div> |
...