WMS Version: starting from 3.88.43544.04
Created: February 2019
Permalink:
Please note that currently SMS functionality is not supported. It will be available later.
Overview and LED indicators
DaySaver Overview
Front panel:1 - SIM slot
2 - SIM LED indicator
3 - LAN LED indicator
4 - RUN
5 - Power LED indicator
6 - WAN LED indicator
7 - 2 antennas
Rear panel:1 - optional power supply
2 - WAN/ PoE
3 - LAN port
4 - Reset button
5 - Reboot button
LED indicators
| Indicator | State | Description |
|---|---|---|
| PWR | Off | There is no power supply or power supply is abnormal |
| On | The device is powered on | |
| RUN | Off | The device is not running normally |
| On | The device is being initialized | |
| Slow flashing | The device is initialized successfully and running normally | |
| WAN/ LAN | Off | Network doesn't work or network cable is not connected |
| Fast flashing | Network is successfully connected | |
SIM | Slow flashing 4 sec | SIM card is not registered |
| Off |
Installation and connection
- Connect GSM antennas to the back panel of the gateway
- Connect network cable to WAN or LAN port
- Insert a SIM card to the SIM slot
Provisioning and configuration
VoLTE configuration
To configure VoLTE, proceed with the following steps:
- Go to Network -> VoLTE
- Check off Enable in Status field
- Click Save
- Confirm by clicking Apply
Factory reset
To perform a factory reset procedure:
- Press and hold Reset button for 10 seconds