DaySaver Quick Installation Guide describes how to connect and configure the LTE gateway.
DaySaver Datasheet: Media Gateways Datasheet
WMS Version: starting from 3.88.43544.04
Created: February 2019
Permalink: https://confluence.wildix.com/x/Z4A2Ag
Please note that currently SMS sending is not supported. It will be available later.
Overview and LED indicators
DaySaver Overview
Front panel:1 - SIM slot: insert and press a SIM card to the slot
2 - SIM LED indicator: shows SIM registration status
3 - LAN LED indicator
4 - Running indicator: indicates network registration status
5 - Power indicator: shows power supply status
6 - WAN LED indicator
7 - 2 antennas: one for data connections; another one - for calls and SMS
Rear panel:1 - DC 12V power supply (optional)
2 - WAN/ PoE port
3 - LAN port (static IP address 192.168.11.1)
4 - Reset button
5 - Reboot button
LED indicators description
| Indicator | State | Description |
|---|---|---|
| PWR | Off | There is no power supply or it is abnormal |
| On | The device is powered on | |
| RUN | Off | The device is not running normally |
| On | The device is being initialized | |
| Slow flashing | The device is successfully initialized and running normally | |
| WAN/ LAN | Off | The is no network connection |
| Fast flashing | Network is successfully connected | |
SIM | Slow flashing 4 sec | SIM card cannot be detected (flashing ever 4 seconds) |
| Fast flashing | SIM card has been inserted and successfully registered (flashing every 2 seconds) |
Installation and connection
Make sure the PIN code of the SIM card is disabled.
- Connect antennas to the rear panel of the gateway
- Connect network cable to WAN/ PoE port
- Insert a SIM card to the slot
Provisioning and configuration
For provisioning of DaySaver, consult Provisioning of Wildix devices Guide.
For remote/unreachable media gateways behind NAT/ Firewall, follow Remote Provisioning of Wildix devices Manual.
After provisioning, the gateway appears in WMS:
- WMS -> Devices:
- WMS -> Trunks:
Important: Status of signal quality is currently not supported!
After the device is provisioned, you can configure its settings. Consult Trunk Settings Guide to check all available parameters.
VoLTE configuration
VoLTE Network allows using DaySaver as a backup for Cloud PBXs, as a backup for the cable Internet connection, or, even as the only Internet access for small offices or during the events.
To use the device as a backup, connect it via LAN to your PC. In case the Internet goes down, DaySaver switches to LTE and uses the cellular data.
Note: IP address of LAN port and IP address of PC must be at the same network segment.
To activate VoLTE, proceed with the following steps:
- Check off Enable in Status field
- Click Save
- Confirm by clicking Apply
After activating VoLTE, network status can be checked in Status -> Overview -> VoLTE Network / Online:
Factory reset and reboot
To perform a factory reset procedure for restoring default settings:
- Press and hold Reset button for 10 seconds
To reboot the device:
- Press and hold Reboot button for 10 seconds
Important: complete initialization and loading can take up to 5 minutes!