Overview and LED indicators
1 - DC 12V power supply (optional, WMP code: PS-12V2A)
2 - FXS ports 1-4
3 - WAN/ PoE port
4 - LAN port
5 - FXS 1-4 LED indicators
6 - Power indicator: shows power supply status
7 - Running indicator: indicates network registration status
8 - Reset button
LED indicators description
The device is powered on
There is no power supply or power supply is abnormal
|RUN||Running indicator||Slow flashing|
The device is running properly
SIP registration is successful
The device is running improperly
|FXS 1-4||FXS In-use indicators||On |
FXS port is currently occupied by a call
FXS port is idle or faulty
|WAN/PoE/ LAN||Network indicators||Green flashing|
The device is properly connected to network
The device is not connected to network or the connection is improper
Installation and network connection
- Connect network cable to WAN/ PoE port
- Connect telephone line to the FXS port(s)
Note: W04FXS 2020 is a wall-mounted Media Gateway.
The Gateway works in two network modes: Route and Bridge modes.
LAN port is configured in Bridge mode and WAN port is set up as a DHCP Client. Connect one of two ports to the same network as the PBX or an external DHCP server (for instance, its router).
As soon as the DHCP server assigns an IP address to the Gateway, you can pass to the next step of the Gateway configuration.
- In case the PBX is used as a DHCP server, the gateway is detected on the network automatically
- In case an external DHCP server is used, check the list of the active leases to detect the IP address assigned to the Gateway
Follow our Provisioning of Wildix devices - Admin Guide to provision the gateway.
For remote/ unreachable media gateways behind NAT/Firewall, follow our online Guide to remote provisioning.
Assign analog ports
Follow our online guide to assign the analog ports of the FXS gateway: Assign analog ports of FXS to users.
Set differentiated ringtones
W04FXS supports differentiated ringtones for internal/ external/ blacklist/ whitelist call classes.
Differentiated ringtones can be set in Dialplan. Add the following Dialplan applications for configuration:
- Set -> Type of call -> select the call class
- Dial the phone -> routes the call to the specified number
Detailed information on Dialplan applications: Dialplan applications Admin Guide.
- Use the paper clip or the object of the similar shape to press the Reset button
- Keep the button pressed up to 15 seconds
- When PWR and RUN LED indicators become steady green, the reset of the Gateway is complete
Control calls using Flash button
Read the document: How to control calls using Flash button on FXS Media Gateways.