Scroll export button | ||||||||
---|---|---|---|---|---|---|---|---|
|
Info |
---|
The document describes how to configure Push-to-talk feature for x-hoppers broadcast. x-hoppers Documentation: x-hoppers Documentation Created: May 2024 Permalink: https://wildix.atlassian.net/wiki/x/AQCIIg |
Table of Contents |
---|
Introduction
...
- x-hoppers-SalesFloorHopper licence or higher
- ACL permission Can see call recordings
- WMS v. 6.07
- x-bees mobile app v. 1.68 or higher
- Note: The XBees Android App requires the "Nearby Devices" permission to be granted.
Configuration
Add the parameter --conf_recording or -ptt to the /etc/systemd/system/pbx-data-engine.service.d/override.conf file.
Example:Code Block [Service] ExecStart= ExecStart=/usr/sbin/pbx_data_engine.py --conf_recording --daemon
Restart the service to apply the changes:
Code Block systemctl daemon-reload systemctl restart pbx-data-engine
For the feature to work on mobile, make sure there is an included procedure pbxservice(Services codes dialplan) set in Dialplan:
- Create a conversation in x-bees, adding all members of x-hoppers broadcast, including all W-AIR headset users and all users of x-bees mobile app, that are going to use the Push-to-talk feature. The transcription and audio files of what was pronounced in x-hoppers broadcast will be added to this conversation.
Add the following lines to the /rw2/etc/pbx/x-hoppers.json file:
Code Block [ { "audio_conf_id": 0, "xbees_channel_id": "a1b88b80-a287-4848-8d1a-9fb8721f" } ]
Where:
“0” is the number of x-hopper conference
"a1b88b80-a287-4848-8d1a-9fb8721f" is the ID of x-bees conversation.
Note Note: The conversation ID is available in the conversation URL:
Restart the service to apply the changes:
Code Block systemctl daemon-reload systemctl restart pbx-data-engine
...
Go to Settings -> Integrations -> enable the toggle next to Allow Push-to-talk option:
Note Note: The Push-to-Talk button under Allow Push-to-Talk can currently be used to connect Jabra Perform 45 headset.
Warning Important: On Android, it is necessary to allow "Nearby Devices" permission for x-bees app for the Push-to-talk feature to work.
Find x-hoppers conversation on the Inbox tab -> press and hold the relevant conversation -> on the pop-up screen that appears below, press the option Enter x-hoppers group:
To send a voice message to x-hoppers broadcast via mobile, user should press and hold the Push-to-talk button next to the message field:
The message is played to users in x-hoppers broadcast. Also, once mobile user enters the x-hoppers conversation, the group messages are automatically played on mobile in Speaker mode.
What is pronounced in x-hoppers broadcast is added as a message from the relevant user with a transcription and audio file:
- To exit the broadcast, go to the Inbox tab -> press and hold the relevant conversation -> on the pop-up screen that appears below, press the option Exit x-hoppers group:
...