...
Requirements
- WMS 6.0X
- W-AIR firmware version 730B200version 730b200
- Supported devices
- W-AIR base station: W-AIR Sync Plus, W-AIR Base Station
- W-AIR handset: W-AIR Med, W-AIR LifeSaver, W-AIR LifeSaver-EX
...
Parameters are stored on W-AIR base station and transferred to W-AIR handset, it is not possible to change them on W-AIR handset:
Name | Setting | Comment |
---|---|---|
Handset mode (2 bit) | Receive beacon, transmit beacon, 1 selectable (drop down) receive and transmit beacon. | 1 selectable (drop down) |
Active mode | ||
Transmit power (6 bit) | 0 to -46dBm in 2 dB steps | 1 selectable (drop down) |
Transmit selection (2 bit) | Select which beacon type to transmit: | 1 selectable (drop down) |
Transmit interval (2 bit) | Interval between each beacon transmit: | 1 selectable (drop down) |
Passive mode | ||
Receive mode (2 bit) | Report beacon information: | 1 selectable (drop down) |
Receive selection (4 bit) 1 extra bit reserved | Select which beacons to receive: | All 3 can be selected |
In W-AIR network with up to 1000 handsets, it is important to use as little space as possible for the parameters. It is not recommended to store the broadcast for each W-AIR handset as this will fill 32kByte on W-AIR base station. The IPEI number should be used as part of the UUID number together with a selectable value that is the same for all handsets.
Transmit beacon content (32 bytes) | Broadcast data of the transmitted beacon (space reserved 32 bytes): | Input of up to 32 bytes |
Sending beacon messages from W-AIR base station/ handset
...